These are the steps to changing the blade
Prepare Your Work Area
Before you start working on the saw you should ensure that your work area is clear. Then, unplug the saw from its power source and place it down on a sturdy surface.
Remove The Blade Guard
The first thing you need to do when changing circular saw blades removes the blade guard assembly so you have access to the blade. Make sure to keep the blade guard assembly somewhere safe so it doesnt get damaged while youre working on replacing the saws blade.Once all screws have been removed, carefully remove the blade guard from the rest of the circular saw and place it to one side.
Unscrew And Remove The Old Blade
Once the blade is exposed, you can use a pair or crescent wrench to remove it from the arbor bolt. To avoid injury or damage to surfaces, always place a circular saw blade on a piece of cloth or a disposable surface when removing it from the arbor bolt. Once youve removed your old circular saw blade, make sure to clean away any debris.
Remove The Blade Guard From The Rest Of The Circular Saw And Place It To One Side.
When youve finished cleaning the surface where your old blade was secured, its time to install the replacement. Apply a thin layer of WD-40 inline with the circular saws arbor bolt threading to help prevent any rust or obstruction during installation. Then slide the new circular saw blade onto the saws arbor bolt and screw it into place using your preferred tool (pliers or wrench).
Replace Blade Guard Assembly
After you have successfully installed your circular saw blade, it is time to replace the guard. Simply line up all corresponding screw holes and carefully attach the blade guard assembly back into place on your Ridgid circular saw.
Check The Blade
After you have replaced the circular saw blade of your Ridgid model’s circular saw blade, plug it back in to its power source and turn it off to test its new functionality.
Tools:
- A Crescent Wrench and Channel Lock Pliers
- A New Replacement Blade
Materials: WD-40 spray lubricant A Shop Cloth
A Video Guide On How To Change Blade On Ridgid Circular Saw?
This video explains how to change the blade of the Ridgid circularsaw.
How to change the blade of a Ridgid circularsaw
Tips For Keeping Your Blades Sharp:
- Keep your saws blade dry and free of debris at all times; moisture will corrode the metal.
- High heat can cause damage to your blades. Even the smallest amount can cause it to melt or warp.
- To increase safety and speed up cutting with a circularsaw, always use full throttle
Conclusion:
FAQ
Which Type Of Blade Are You Looking For?
The type of blade you need will depend on the specific project youre working on. If you are using your Ridgid circular-saw to build a birdhouse, then you will need a fine-toothed knife (20 to 24 teeth per inch). If you are cutting 2x4s for deck construction, a coarse-toothed, with fewer teeth per in, is recommended. Replace your circular saw blade according to material and thickness.
How Do You Remove The Old Blade?
There are several ways to remove a circular saw’s blade. Many people attach the blade to the wrench or pliers and unscrew the bolt by hand, others use their hands or other tools; it all depends on your level of experience and which method you find works best for you. You can puncture your palm by using the most common method, so be careful when removing blades.
Which Replacement Ridgid Parts Should I Buy?
Before replacing any Ridgid accessory, ensure that it is compatible with your model. There are many options for replacement blades. Multi-packs of Ridgid replacement knives can be purchased to save money over the long term.
What’s An Auxiliary Handle?
It is also called the pawl step which prevents kickback by engaging the top of the blade. It attaches to the side of blade guards on some models, but not all make/models have this feature built-in like Ridgid band saws do check out my band saw a review here. Only certain models and makes of circular saws require an auxiliary handle. If you aren’t familiar with the process, make sure to consult the manual before installing.
